Groove Router
As via a slot at the edge of a curved piece of wood?
I cut a semicircular groove in the edge of a piece of wood. If the piece was straight I could do it easily with a core drill, but because the piece is bent I can not imagine how to make work, and have found no other Strawberries that seem to help. Any ideas?
I would make a new base with 1 / 2 "plywood. Drill a hole in the center to remove bits. Fix two pieces of dowel to the bottom of the plate. This is a bit beaten and losing the setting but basically they are trying to introduce a dual point of contact. If you can get out of the workpiece large slot cut and then finish with the size that simplifies the problem of operating the slot end of the work.
V-groove Dibond with Saw Trax Panel Router and Panel Saw
|
|
Freud 99-036 Adjustable Tongue and Groove Bit Set, 1/2-Inch Shank
$114.30 An industry leader for over 50 years, the Freud name equals quality, precision and craftsmanship. Freud router bits feature Freud made TiCo Hi-Density Carbide for maximum cutting life. Each bit is individually balanced, giving a cut above the rest. Trim carpenters, remodelers, and woodworking enthusiasts can now mill molding of almost any size, shape and configuration to add beautiful detail to ... |
|
|
MLCS 200 Solid Carbide Spiral Upcut Bit Starter Set, 3-Piece
$69.95 Three SOLID MICROGRAIN CARBIDE bits for fast, smooth cuts and an edge that stays sharp longer. Spiral Bits produce a very clean and accurate cut with minimal chatter. Upcut spiral helps remove material from the groove. They work well for deep mortises, cutting dadoes in a router table, and any edge treatment done with the work facing upward. Includes the following diameter UPCUT Bits: 1/4" D (1" ... |
|
|
MLCS 7733 60-Degree Woodworking Edge Banding Tongue and Groove Set, 1/2-Inch Shank, 2-Piece
$44.95 Add an attractive and durable edge to your cabinet doors and shelf edges. For use with plywood panels, MDF panels or shelves from 1/2" to 1" thick. All matched 2 piece bit sets are two-flute, carbide-tipped. Simply center the male cutter on the stock and make the cut. Next match up the female cutter with the center point of the first cut. Finish by gluing together the two pieces and flush trim the... |
